TYGA flywheel/RC valve remover, Honda NSR125/150/250/300

This new, TYGA designed 2 in 1 combination tool is a flywheel puller and RC valve removing tool all in one handy package.

Saves space in your toolbox, and less clutter on the work bench.

How to use:

Familiarise yourself with the parts (see picture).

The tool is delivered ready for use as a flywheel puller. Just screw part D into the crank, then wind the (left hand) threaded main body (part A ) into the flywheel centre and pop the flywheel off by rotating part B clockwise. Part C is not used.

For removing the RC valve shaft remove part B completely and refit from the opposite end, screwing all the way home. Then slide in the part C . Position the tool over the valve shaft and wind part C onto the RC valve shaft (left hand thread). When fully home just rotate part B anti-clockwise to pull out the shaft. The RC valve shaft seal and E-clip will probably be damaged in the process, and should be replaced. Part D is not used.

22mm and 19mm spanners (not supplied) are required for correct operation.

*Note* This tool can be used on the NSR150 to remove the RC valve shaft, but will not fit the flywheel. Please use TYTO-0007 for this job.